|
/?=poll("basic"); // 설문조사 ?-->
/?=connect(); // 현재 접속자수 ?>
|
|
작성일 : 05-04-14 08:10
[막가표 발판 시리즈(2) 2A3/45] 45 와 2A3 호환여부
|
|
글쓴이 :
막
조회 : 1,343
|
Primary Z of OPT
Some people have expressed concern on the use of 5k or greater load for a 2A3 which only requires 2.5K according to the tube manual. Well folks, the operating point as stated is for a 45 and since the 2A3 is not at its most linear region under these conditions, a higher impedance load reduces distortion and improves damping factor in the low frequencies. I've measured 2.5W output from this circuit using 2A3s and it sounds more dynamic and punchy which some may prefer over the mellower and more refined 2W of a 45.
이글은 만든넘에서 발췌한 것임.-- 이회로는 45에 맞게 설계되어 있지만 2A3시 5k load가 linear하지 않지만 높은 부하로 왜곡이 줄고, 45보다 output impedance가 적어지므로 저역이 좋아진다는 같슴. 파워는 동일하다함
James 6113은 primary 가 2.5k, 5k 둘다 있어 스위치달몬 2A3시 2.5k로 바꿀수도 있습니다.
곧 막의 발판45는 초단만 다르고 전압이 위의 회로와 동일하므로 2A3를 박아서 소리를 한번 들어보죠. 머..
|
Total 396
|
|
|
|