EM800 로 간단한 레벨 미터를 만들다 보니, 전압이 안나오는곳이 있어서 질문드립니다.
제너 다이오드 4751A (30V) 를 썼는데, 도무지 30V 안만들어 집니다.
여러개로 별도로 시험도 해보고 했는데요. R4, 100K 로 하면, 제너에는 100V 이상이 나타납니다.
이 저헝을 카우면, 그에 따른 전압강하만 보입니다. 제너는 통역할을 못하고 잇습니다.
그리고, 스피커 출력단을 입력했는데, 소음량에서는 좀 움직임이 약해서...
혹시 TR에 고전압이 (100V) 가해 져서 제댜로 증폭을 못하는것이 아닐까 의심을 해봅니다.
기초중에 기초인데, 제너로 정전압이 안나오는 이유를 모르겠습니다.
The circuit is operated from 250V DC, connected to X1. Filament Voltage is connected to X3.
An auxilliary Voltage of about 30 Volts is generated by R4, D1 and C2. R1 should be chosen to allow for about 1 -2mA of current through the Z-Diode.
The Resistor R4 has about 220 V of Voltage drop, which means about 400mW of power dissipation. Use only resistors rated for this high Voltage and Power dissipation!
Componet values for 250V Operating Voltage
(input sensitivity aproximately 1V)
R1 10k
R2 470k
R3 1M
R4 100k/1W
R5 47k
R6 1M
R7 56k
R8 adjustable 100k
R9 2.7k
C1 100nF
C2 10µF/35V
C3 100nF
C4 100nF
D1 30V Z-Diode
D2 1N4148
D3 1N4148
Q1 BC546
Preamp Stage design:
The tube needs about -10 V for full illumination, so the preamp stage must be able to provide this level.
The component values given above give about 20X amplification.
If you need a high impedance input, you can replace the input transistor with a Mosfet and suitable resistors.
|